3yakuya's user avatar
3yakuya's user avatar
3yakuya's user avatar
3yakuya
  • Member for 5 years, 2 months
  • Last seen this week
4 votes

Accuracy of Grover algorithm is 100% for 2 qubit, 94.5% on 3 qubit and 96.2% for 4 qubit on simulator. Why it decreasing and then again increasing?

3 votes
Accepted

Simulating a quantum circuit with decoherence and noise

3 votes
Accepted

Why is sampling from probability distributions generated by specific quantum circuits classically intractable?

3 votes

What time complexity is considered difficult for quantum computers?

2 votes

Does each qubit correspond to some wave?

2 votes
Accepted

How many quantum gates are needed to prepare an arbitrary state?

1 vote

How to simulate the state of a system after partial measurement?

1 vote

Oblivious Amplitude Amplification

1 vote

Qubit identities get swapped in IBM Qiskit

1 vote

How to implement general 2-qubit gate in n-qubit system?

1 vote

How can I run a VQE on one of IBMQ's Quantum Computers

1 vote

Do individual qubits on IBM quantum processors share the same control unit?

1 vote
Accepted

Variational quantum eigensolver in qiskit

1 vote

How to construct a parameterised UCCSD ansatz?

1 vote
Accepted

Is it possible to set quantum volume in IBM Quantum simulator?

1 vote
Accepted

Quantum Image Processing Application

1 vote

How to calculate the number of qubits in surface code, for given physical error rate

1 vote

Is amplitude encoding a form of performing QRAM?

0 votes

Do not understand error in if-else section

0 votes

Can the ancilla for Qiskit's mcx with mode="recursion" be dirty?

0 votes

How does one use the Qiskit CDMKRippleCarryAdder?

0 votes
Accepted

Error : Cannot unroll the circuit to the given basis

0 votes

Qiskit does not interpret qasm string as 3.0?

-1 votes

What does a statevector with 3 elements (in Qiskit) represent?