1
$\begingroup$

I've been using the teleportation protocol to teleport qubits and then using Qiskit state tomography for reconstructing my qubits.

Using this circuit using open qasm I regularly obtain fidelity 0.9. circuit using teleportation protocol

But using the same on a quantum computer returns fidelity 0.5-0.8. Is that normal? I mean, doing tomography implies using more shots and that gives more noise after every measurement.

I also tried doing the measurements at the end but the fidelity didn't improved.

$\endgroup$
4
  • 2
    $\begingroup$ This may help quantumcomputing.stackexchange.com/questions/8682/… $\endgroup$ Aug 29 at 7:40
  • $\begingroup$ It may depend on the quantum professor too, try different backends. $\endgroup$
    – Mauricio
    Aug 29 at 8:25
  • $\begingroup$ Thank you! But as is see the computational error was before the implementation on mid-circuit measurement. Do you think that because of that my circuit is possible? $\endgroup$
    – felipechoy
    Aug 29 at 17:52
  • $\begingroup$ I mean, it runs but I don't know if is normal the relatively low fidelity due to noise in the quantum computer. $\endgroup$
    – felipechoy
    Aug 29 at 17:53

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Browse other questions tagged or ask your own question.